martinl
18.07.00, 22:15
Can anyone here advise on how to setup my Eco8 with Profi 3030 on Mode 1 for CCPM120 deg. Setup are arranged as follows...
A=yaw, B=nose u/d, C=roll,D=collective,
E=dyn trottle, S5=auto.
I have applied head-mix to B,C,D
I have assigned the servo to a JR rx arrangement 1=trottle,2=aileron,3=elev,4=rudder,
5=gear,6=aux1
I have managed to get all the servos working the way I setup my previous JR388 EXCEPT I
cannot get the collective and trottle to work together. Because the trottle is assigned to E and E is not in the head-mix. 120 deg is a 3 point linkage,
Should I add head-mix to E, then the geometry
of the swash will be incorrect.
Please email me if you can help..
martinl@melbpc.org.au
A=yaw, B=nose u/d, C=roll,D=collective,
E=dyn trottle, S5=auto.
I have applied head-mix to B,C,D
I have assigned the servo to a JR rx arrangement 1=trottle,2=aileron,3=elev,4=rudder,
5=gear,6=aux1
I have managed to get all the servos working the way I setup my previous JR388 EXCEPT I
cannot get the collective and trottle to work together. Because the trottle is assigned to E and E is not in the head-mix. 120 deg is a 3 point linkage,
Should I add head-mix to E, then the geometry
of the swash will be incorrect.
Please email me if you can help..
martinl@melbpc.org.au