Brushless with piccoboard

[steve20]

This may seem stupid but I was looking up connections between brushless S/C and piccoboard, for future ref, and there seems to be different ones depending on whether you have a PB with receiver or a seperate receiver.Is this the case, and if so what is the difference. Just wondering. [img]/ubbthreads/images/graemlins/confused.gif[/img] CHEERS !

The connections are the same, no matter which receiver you use:
The signal from the receiver throttle channel output needs to be connected to
a.) the throttle signal input of the Piccoboard controller and
b.) your brushless ESC

Basically what Panem said in the form of a picture! [img]/ubbthreads/images/graemlins/smile.gif[/img]

[ QUOTE ]
Basically what Panem said in the form of a picture! [img]/ubbthreads/images/graemlins/smile.gif[/img]

[/ QUOTE ]
You want pictures? Ok, here you go..... [img]/ubbthreads/images/graemlins/grin.gif[/img] [img]/ubbthreads/images/graemlins/grin.gif[/img] [img]/ubbthreads/images/graemlins/grin.gif[/img] [img]/ubbthreads/images/graemlins/grin.gif[/img]

:

[steve20]

Cheers guys, they were the pictures that I had but with panem's one I had an extra picture showing setup with the piccoboard receiver with a different wiring diagram. If it doesn't make any difference then it should be easy. Thanks once again. [img]/ubbthreads/images/graemlins/smile.gif[/img]