Piccoboard plus

[taxi]

Hi Guys, I just got my new PB-Plus, there are two servo leads 1 for tail motor and 1 for main motor it seems that I have to connect these onto the other side of the board where the RX pins are, is that correct only they are not very long.
Thanks a lot

[timsmith]

Yes. Those are the cables which connect the channels on the Rx side of the Piccoboard to the speed controllers/gyro.

Which channel they go into depends on which Tx make you have. I cant remember for JR but Im sure your manual will tell you.



Tim

[pgoelz]

JR I think is 1-4 = throttle, aileron, elevator and rudder. The leads should be long enough to reach. Your hardest task is to determine which connector on the receiver is channel #1. I don't think Ikarus labels them. The leads themselves are marked in German on the Piccoboard. GAS = throttle and HECK = tail (rudder).