Proper governor setup for Jazz controller?

Once the controller is programmed in heli mode, how should I set it up so it knows maximum rpm of the motor?

Can it be set up according to the instructions for the smile controller on the Dream-Models site or does it need to be under a load with the blades on?

C and P from Dream-Models site

When using mode 4, governor or heli mode, you need to apply the following procedure every time you change battery type or pinion.


Set mode 4 as per instructions in the manual
Remove the blades, Set a throttle curve of 0 to 100 and reconnect a freshly charged pack and let the ESC beep saying its ready for flight. I put some broom stick in the skids to keep it from wiping around and advanced the throttle to full open. After a few seconds it changes in rpms and goes up some and them remains steady. At this point I lowered it to 0 and unplugged the pack. Put blades back on and go

[BertVK]

I assume the same logic was used when they created the Jazz controller software. I'd use the same principle.